0 Red Rack And Pinion
0 // X/Z studs, Y plates; converted to LDraw units
0 // Lay the rack-and-pinion foundation
1 7 60.0 -8 80.0 0 0 1 0 1 0 -1 0 0 3036.dat
0 STEP
0 // Tile the smooth rack guide
1 7 50.0 -16 40.0 0 0 1 0 1 0 -1 0 0 3069b.dat
1 7 50.0 -16 80.0 0 0 1 0 1 0 -1 0 0 3069b.dat
0 STEP
0 // Lay the four-stud rack on the smooth guide
1 7 50.0 -30 60.0 0 0 1 0 1 0 -1 0 0 3743.dat
0 STEP
0 // Build the two-plate axle support
1 4 30.0 -16 80.0 0 0 1 0 1 0 -1 0 0 3023.dat
1 4 30.0 -24 80.0 0 0 1 0 1 0 -1 0 0 3023.dat
0 STEP
0 // Add the axle bearing above the support
1 4 30.0 -48 70.0 0 0 1 0 1 0 -1 0 0 6541.dat
0 STEP
0 // Slide a six-stud axle through the bearing
1 0 60 -38 70 1 0 0 0 1 0 0 0 -1 3706.dat
0 STEP
0 // Retain both ends of the axle
1 7 10 -38 70 0 0 1 0 1 0 1 0 0 3713.dat
1 7 90 -38 70 0 0 1 0 1 0 1 0 0 3713.dat
0 STEP
0 // Mesh the 8-tooth pinion with the rack
1 7 50 -38 70 0 0 1 0 1 0 1 0 0 3647.dat
0 STEP